Your Electro arc Machine is durably built, thoroughly tested, and inspected at the factory. You can expect many years of service with minimal maintenance. To maintain the accuracy, dependability, and cutting speed built into your metal disintegrator, please heed these warnings and recommendations for machine and operator safety. Warnings: When…
10 Ways you can use Electro Arc Metal Disintegrators
When you think of a metal disintegrator you probably think of removing broken taps. Electro Arc metal disintegrators have a variety of uses. Disintegrating hard metal is easy with our machines! A minute arc causes the disintegration process at predetermined intervals. These arcs burn microscopic pieces of your work metal.…
5 Steps to Choose the Machine You Need to Remove Broken Bolts
Our broken bolt, drill, and tap removal technology is the most cost-effective and precise method available in the market. Patented in 1942, AC metal disintegrators were made and distributed exclusively by Electro Arc for years before competitors entered the market. Electro Arc purchased Uni-Tek in 2004 and began making and…
How to Remove a Broken Tap Quickly
Electro Arc’s 3-S portable metal disintegrator is featured below. You do not need dielectric fluid to use this machine, just coolant. The 3-S is easy on your pockets and convenient for you to use. Our metal disintegrators remove broken taps and drills without damage or coming into contact with the…
How to Remove Broken Drill Bit From Metal
Are you wondering what the best way to remove broken drill bits from metals is? Electro Arc has been providing high-quality broken tap, drill, stud, and bolt removal EDM / MDM machines since 1947. Our technology safely removes the broken drill in seconds without causing any damage to your part.…
IQ Head Adjustment on a Metal Disintegrator
Below is a transcription of the above video. If you have any questions about our broken drill, tap, and spark erosion machines then contact us on our contact page. In this video we are going to demonstrate how to restore your IQ head back to the 20,000 factory setting for…
Watch a Broken Drill Removed From Manifold
The following is a transcription of the above video. Please reach out to us here with any questions or concerns. Hi and welcome to Electro ARC. Today we’re going to be demonstrating our DC direct current output disintegrating transformer which is optimally suited for removing broken carbide tooling. We have…
Rivet Removal Using Broken Tap Remover
Using A Broken Tap Remover On A Rivet Did you know that you can use Electro Arc tap removers to remove broken rivets? You can see a demonstration of our Bolt Eater machine removing a rivet in the above YouTube video. Electro Arc began offering the Bolt Eater(TM) in 2004…